Search:

Type: Posts; User: D-der

Page 1 of 12 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    1,125
    Views
    127,019

    My 642 UC came in missing the rear sight set...

    My 642 UC came in missing the rear sight set screw, 2 weeks after speaking with S&W CS and being assured they would promptly send one, I called yesterday, it seems it was never sent because on their...
  2. Replies
    1,211
    Views
    151,580

    An X Macro is my daily primary carry but I've...

    An X Macro is my daily primary carry but I've been kind of preoccupied and wrapped up with J frame's lately and haven't shot the Macro, after finishing up with a snub earlier I drew the Macro a few...
  3. Replies
    1,125
    Views
    127,019

    119026 There was a break in the rain this...

    119026

    There was a break in the rain this morning so I ran another 60 rds through my UC at 8 yds and a pretty quick pace and some on steel at 15-20 yds. So far, I'm at 140+ rds since putting in...
  4. Replies
    15
    Views
    517

    Sticky: Pucker up!

    Pucker up!
  5. Replies
    1,125
    Views
    127,019

    118939118940118941642UC I spent a little time...

    118939118940118941642UC

    I spent a little time with my 642UC yesterday, Early morning I put in an Apex kit that I've had but never used, dry fired 100 +/- time's with good results, the trigger...
  6. Replies
    20
    Views
    1,013

    I did this option and cleaned up the crude...

    I did this option and cleaned up the crude stamped trigger bar while I was there, wound up with a real impressive sub 4lb trigger, I'd experiment further if I were going to carry it.
  7. Replies
    1,125
    Views
    127,019

    I'm still trying to sort out my best sight...

    I'm still trying to sort out my best sight picture with my 642 UC, bottom out the dot and drive the dot or, align the sights and run a low 6:00 hold, add old guy eyesight and progressive...
  8. Replies
    1,125
    Views
    127,019

    Excellent review's, I'd pretty much agree on the...

    Excellent review's, I'd pretty much agree on the sight picture, I'm not going to shoot the balls off a fly but, at 7-10 I'm pretty much on a 3x5 card.
    I'd also agree with the grips feeling a little...
  9. Replies
    1,125
    Views
    127,019

    Thanks, I'd been using my LCR Aholster with my...

    Thanks, I'd been using my LCR Aholster with my Pro, worked fine but no clearance for the UC rear sight, just time for another holster I guess
  10. Replies
    1,125
    Views
    127,019

    AFR has a video on J frame lubing and mentioned...

    AFR has a video on J frame lubing and mentioned the UC. Last night I pulled the side plate and didn't notice any debris but aside from what migrated from my initial exterior lubing by shooting and...
  11. Replies
    1,125
    Views
    127,019

    I picked up my 642 UC Friday afternoon, I lubed...

    I picked up my 642 UC Friday afternoon, I lubed and ran a patch through it when I got home,
    the chambers and bore were clean but, it really needed some oil, the gun was dry and kind of stiff but,...
  12. Replies
    13
    Views
    1,201

    Some good stuff, bookmarked it, Thanks

    Some good stuff, bookmarked it,
    Thanks
  13. Replies
    1,125
    Views
    127,019

    This has me anxiously waiting for a phone call,...

    This has me anxiously waiting for a phone call, hopefully sooner than later now.
  14. Thread: Lubed my 642

    by D-der
    Replies
    4
    Views
    466

    Thanks, I stoned the block and used Lucas Extreme...

    Thanks, I stoned the block and used Lucas Extreme oil on all the lube points, grease sounds like a problem
  15. Thread: Lubed my 642

    by D-der
    Replies
    4
    Views
    466

    Lubed my 642

    Several months ago I'd received my 642 Pro back after 2 trips to S&W, the first trip was for a broken stud and the frame was replaced, I had the gun for about 2 weeks ran 2-3 cylinder's and it went...
  16. Thread: Recommend a 22lr

    by D-der
    Replies
    45
    Views
    3,138

    I've read a lot good feedback on the TX200,I...

    I've read a lot good feedback on the TX200,I think I'm going to pick up a compact, red dot ready, it should make for a good plinker / inexpensive trainer
  17. Replies
    17
    Views
    1,422

    I mark the case with a sharpie line, 5 lines and...

    I mark the case with a sharpie line, 5 lines and it goes in the drill pile,
    I do measure one here and there and have found very little or no length
    change with HST's and never had a problem with...
  18. Replies
    1,125
    Views
    127,019

    Good for you! I'm anxiously awaiting a similar...

    Good for you! I'm anxiously awaiting a similar call...sooner or later.
  19. Replies
    91
    Views
    17,755

    Too bad these aren't more consistent with POA /...

    Too bad these aren't more consistent with POA / POI and at least as pocketable as an LCR, I was originally very optimistically waiting for the UC' s to become available, there's been mixed feed back...
  20. Replies
    130
    Views
    10,322

    After carrying an XMacro for month's I figured...

    After carrying an XMacro for month's I figured I'll be going back to one of my XL' s at times with warm weather and thinner shirts, since I hadn't shot one in a while, I pulled one out of the safe...
  21. Replies
    1,125
    Views
    127,019

    Wondering about A-Holster

    Wondering about A-Holster
  22. Replies
    1,211
    Views
    151,580

    Those do look pretty nice, I'm thinking it won't...

    Those do look pretty nice, I'm thinking it won't fit in a JM 2.5 though.
  23. Replies
    130
    Views
    10,322

    Just good business, no need to piss off currant /...

    Just good business, no need to piss off currant / future customers
  24. Replies
    130
    Views
    10,322

    I'm at my desk, at work reading this, XMacro...

    I'm at my desk, at work reading this, XMacro AIWB, on a MM belt wearing an untucked shirt with a 642 in my right front pocket,
    When I go to PT one or two days a week for a strong side shoulder...
  25. Replies
    34
    Views
    3,169

    +1 On the Howie's tape, got a roll last week.

    +1 On the Howie's tape, got a roll last week.
Results 1 to 25 of 300
Page 1 of 12 1 2 3 4