At first I thought.....well, I'd better clean everything up so it looks good, but then realized that I'd never post the pic or information up! So here it is...I have a couple of other work area for rifle tinkering, pistol cleaning, etc.
The Forster Coax is for run of the mill rifle cartridges: .223, .204, 6X45, 6.8SPC, .260 etc...mostly prefer Redding dies.
The Lee 4-hole turret press on the right side of the table is for pistol loading: 9mm, .40 & .45....using Lee Carbide dies...very happy with them.
For precision rifle work (6.5X47 Lapua/6BR--600yd and 300yd matches) I used the 21st Century arbor press and Wilson neck dies and seater, with Redding Titanium bushings.
For primer seating, I can't say enough about 21st Century's hand primers....I have two and wouldn't want to use anything else.
I use the RCBS Chargemaster electronic powder dispenser.....I've used a wide variety of methods over the last 30 years, and find it to be dependable and accurate.
As you can see, I"m not a high volume reloader, and since I'm retired I have the time to do it my way, and make it right.